10bbl brite tanks manufacturer is used in petroleum, chemical, rubber, pesticide, dye, medicine, food scientific research and other industries. It is used to complete vulcanization, nitrification, hydrogenation, alkylation, polymerization, condensation and other processes. As well as 10bbl brite tanks manufacturer equipment for many processes such as organic dyes and intermediates. Do you know how to properly install and commission 10bbl brite tanks manufacturer? Today, Xinchangyuan Xiaobian will explain it to you.
1. Check whether the movable parts and fixed contacts on the panel and back panel are normal, remove the upper cover, and check whether the contact of the connector is loose, and whether there is damage or rust caused by poor transportation and storage.
2. When installing the kettle cover, the sealing surface between the kettle body and the kettle cover should be prevented from bumping against each other. Place the kettle cover carefully on the kettle body in a fixed position, and tighten the main nut in a diagonal and symmetrical manner. The force should be even, and the kettle cover should not be allowed to tilt to one side to achieve a good sealing effect.
3, high pressure 10bbl brite tanks manufacturer should be placed indoors. When installing multiple autoclaves, place them separately. Each operating room shall have an outlet directly leading to the outside or passageway, and the equipment location shall be well ventilated.
4, the positive and negative nut connection, only allowed to rotate the positive and negative nuts, the two circular sealing surface shall not rotate relative, all nut grain connection parts are assembled, should be coated with lubricating oil.
5. Hand pan the rotary body on the autoclave to check whether the operation is flexible.
6, needle valve line seal, just gently turn the needle, compress the cover, you can achieve a good sealing effect.
7, the controller should be placed on the operating table, the working environment temperature is 10-40℃, the relative humidity is less than 85%, the surrounding medium does not contain conductive dust and corrosive gases.
8, after the end of the operation, it can be cooled naturally, cooled by water or placed above the support. After the temperature drops, release the pressurized gas in the kettle, reduce the pressure to normal pressure (the pressure gauge shows zero), and then loosen the main nut symmetrically and equally, and then remove the main nut, and then carefully remove the kettle cover and place it on the support.
9. After each operation, the residue on the tank body and cover of the 10bbl brite tanks manufacturer should be removed. The main sealing mouth should be cleaned frequently and kept clean, and it is not allowed to be wiped with hard objects or rough surfaces.
10bbl brite tanks manufacturer https://www.haishunmachinery.com/BREWING/BriteTank/TOPHEADMIRRORPOLISHHAISHUN/10BBLBriteTanks.html
